If you need any further help, please don’t hesitate to contact us directly. Once ACE is properly authorized and installed, you’ll be all set for the future: newer updates to the component can be installed, or it can be uninstalled and even reinstalled, without requiring any further system-level authorization. Note: Although the command used is for kext-consent, the ACE component is not a kernel extension. Launch one of our ACE-powered apps again, and you'll be able to proceed through the installation. Once booted into Recovery, open the Terminal utility there and enter the following commands:Īfter entering those commands, restart your Mac. To enter the Mac's Recovery mode, follow Apple's instructions for Intel or for Apple Silicon. This is done by entering the Mac's Recovery mode and applying adjustments to its security policy, using the spctl utility. If MacOS still fails to show the correct prompt to authorize our ACE component for use, you’ll need to manually authorize it. If the above steps do not cause the authorization prompt to appear properly, you can follow the next set of steps to manually authorize ACE. Run one of our ACE-powered apps again to be guided through the installation process again. Select that folder, and move it to the Trash.Ĭonfirm this action in the Finder when prompted. In the window which appears, you'll see a ACE.driver folder.
Be patient, after a while the Omnisphere registration window will open and provide you with a Challenge Code. If it doesnt open then uninstall your Anti Virus and Turn Off your Windows Defender. In the folder field, enter the following location:Ĭlick the Go button. Cannot load soundsource 'ARP 2600 Sawtooth' from the directory 'Trilian Library' File ARP 2600 Sawtooth.In the Finder, select the Go to Folder… command from the Go menu.
(That's Airfoil, Audio Hijack, Loopback, Piezo, and/or SoundSource.) Quit System Preferences, as well as any and all apps from Rogue Amoeba that are powered by ACE. If you’re still unable to proceed with installing or authorizing ACE from the current release, manually deleting any copy of our component on your Mac will allow MacOS to present the necessary authorization prompt again. The new copy will prompt you to complete the setup process, after which you'll hopefully be set.